Overview
The 2024-onward Vantage uses a reworked AMG M177 V8 producing 665 PS. The oil service follows the same fundamental process as the previous-generation car, but the exact specification must be verified against the manufacturer's documentation for this updated engine.
Applies to: vantage.
Tools and consumables
Tools
- Lift or secure axle stands: The car must be safely and level supported.
- Socket, Torx, and trim-fastener tools: For underbody access and drain plug.
- Drain pan and clean funnels: Sized for the full oil capacity of the reworked M177.
- Torque wrench: For drain plug and filter housing to correct specification.
Consumables
- Approved engine oil: Exact specification for the 665 PS reworked M177. Do not assume the same grade as the previous-generation car without verifying.
- Oil filter: Confirm by VIN — the reworked engine may require a different filter.
- Drain plug seal: Replace at every service.
Preparation
- Confirm the exact oil specification and quantity for the 2024-onward Vantage.
- Gather all tools, consumables, and a clean drain pan.
- Raise and secure the car safely and level.
Access
- Remove underbody panels to expose the sump and filter area.
- Note any changes in layout compared with the previous-generation car.
Drain and remove
- Position the drain pan and remove the drain plug.
- Allow the oil to drain fully. Inspect the old oil for condition.
- Remove and inspect the old oil filter.
Install and refill
- Fit a new drain plug seal and torque to specification.
- Install the new oil filter with correct seal seating.
- Refill with the exact approved oil to the correct level.
Final checks
- Run the engine and check for leaks.
- Recheck the oil level after settling and top up if needed.
- Refit panels and reset any service indicator.
Torque and specs
| Item | Value | Status |
|---|---|---|
| Engine oil grade | To be confirmed by workshop manual | Verify manual |
| Oil fill quantity | To be confirmed by workshop manual | Verify manual |
| Drain plug torque | To be confirmed by workshop manual | Verify manual |
When to stop and call a specialist
- If any fastener or access point differs from expected and you are unsure.
- If the underbody reveals unexpected damage or seepage.
- If you cannot confirm the exact oil specification for this engine version.
Frequently asked questions
Can I use the same oil specification as the previous-generation Vantage V8?
Do not assume so. The reworked engine may have different requirements — always verify against current manufacturer documentation.